|
|
本帖最后由 hlhchina 于 2011-11-30 21:38 編輯
' E) ?5 i) k+ r! t6 I1 z
6 A+ d6 c0 N+ ~4 M我在做金屬切削仿真，在金屬切削仿真中采用自適應網格,，但是在網格檢查時出現自適應不能使用單元畸變控制�,。,。�' T% x- f1 M2 A* s) }5 P
問題描述如下：6 ~) A, v+ O! Q) z6 b; a. O
Adaptive meshing is not supported for elements used with the distortion control. # p! G6 v# i8 ?8 n+ n- ~" }
Domain name: assembly_adapt8 { J# D* i9 s* n+ b# I
Abaqus/Explicit Packager exited with an error - Please see the status file for possible error messages if the file exists.2 h5 s$ z# B' W1 A, ` `2 @! X% d
1 p m1 M" H! t2 }5 U
但是不用網格畸變控制吧,，又出現了網格畸變問題：
5 r. }- `" b4 @9 v" l1 KThe elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
3 B7 }) {3 [! U& m* eThe elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass./ b( D( u) ~( w* B! P
Print-out suppressed for subsequent distorted elements5 H, k3 p( c8 C2 x" k: C
There are a total of 60 excessively distorted elements.- z! C; R6 k, f1 w- P3 y2 y
請求各位達人幫助,，萬分感謝！�,。�; F7 H: u: @+ W: ~4 a
|
|
發表于 2011-11-30 20:51:21
QQ好友和群
收藏
淘帖
問題專業,，描述清楚
伸手黨/灌水/看不懂
