金屬切削仿真中采用自適應網格時出現不能使用單元畸變控制

hlhchina

. x  B# y& m/ @& c7 N7 `& B
, d- g8 n6 m4 M我在做金屬切削仿真,，在金屬切削仿真中采用自適應網格，但是在網格檢查時出現自適應不能使用單元畸變控制�,。�,！
問題描述如下：
$ r. C! M6 r9 ]9 Z: }) Z1 RAdaptive meshing is not supported for elements used with the distortion control.
Domain name: assembly_adapt
5 d/ h: @3 c* W0 E. KAbaqus/Explicit Packager exited with an error - Please see the  status file for possible error messages if the file exists.
: G3 y: f% v4 w' {
但是不用網格畸變控制吧,，又出現了網格畸變問題：
+ [& N$ ~$ I0 m% ]! B% L5 r! fThe elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
! Z0 G+ v3 P  u# _- kThe elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.
9 H0 c3 [* M* ZPrint-out suppressed for subsequent distorted elements
There are a total of        60 excessively distorted elements.
& m2 V  i; P  A1 G5 }請求各位達人幫助，萬分感謝�,。,。�

閑庭信步逸

有人回復嗎

AdaptER

老哥,，您這個問題解決了嗎,？